|
| |
TM 9-2320-364-20-5
17-113
(5)
Install three locknuts (2) on two screws (4) and screw (3) on tab A.
(6)
Measure distance between tab B and cab floor.
NOTE
If distance measured in Step (6) is less than 1/16 in (1.6 mm) proceed to Step (9).
Number of washers used in Step (8) may vary depending on size of gap between tab B and
cab floor.
(7)
Remove screw (3) from tab B side of seat support (5).
(8)
Position washer(s) (6) between tab B and cab floor.
(9)
Position screw (3) in tab B of seat support (5), and install locknut (2).
b.
Follow-On Maintenance.
Remove wheel chocks (TM9-2320-364-10).
END OF TASK
|
