|
| |
TM 9-2320-364-20-5
18-9
NOTE
Wear pads may have shims.
Perform Step (6) if wear pads
have shims.
Note location and number of
shims after removal.
(6)
Remove screw (10) and shim(s) (11) from
two wear pads (8).
(7)
Repeat Steps (5) and (6) for outer-mid
section and boom base section.
c.
Installation.
Adhesives, solvents and sealing compounds can burn easily, can give off harmful vapors and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent or sealing compound gets on skin or clothing,
wash immediately with soap and water.
If installing new wear pad or changing shim amount or size, screw must not protrude
through back of wear pad or damage to equipment may result.
NOTE
Install shims as noted during removal.
Beveled side of shim faces away from wear pad.
Wear pad may or may not require shims.
Perform Steps (1) and (2) if wear pads have shims.
There are three sets of wear pads. They are installed the same way. Inner-mid and fly section
are shown.
(1)
Apply sealing compound to threads of two screws (10).
(2)
Install shim(s) (11) and two screws (10) on wear pads (8).
(3)
Apply grease to contact surface of two wear pads (8).
8
11
10
|
