|
| |
TM 9-2320-364-20-5
18-11
Adhesives, solvents and sealing
compounds can burn easily, can
give off harmful vapors and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
If installing new wear pad or
changing shim amount or size,
ensure correct screw is installed.
Screw must not protrude through
wear pad and wear pad must fit
tight or damage to equipment
may result.
NOTE
Wear pad may or may not require
shims.
(7)
Apply sealing compound to threads of two
screws (3).
(8)
Install wear pad (6), shim(s) (5), two
washers (4) and screws (3) to inner-mid
section (7). Tighten screws (3) to 31 lb-ft
(42 N.m).
(9)
Apply grease to wear pad (6).
(10)
Repeat Steps (7) through (9) for outer-mid
section and boom base section.
d.
Follow-On Maintenance:
Load test crane, (TM 9-2320-364-34-2).
Stow crane, (TM 9-2320-364-10).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
5
6
3
4
7
|
