|
| |
TM 9-2320-364-20-5
20-31
c.
Installation.
Prolonged contact with
lubricating oil (MIL-2104) may
cause a skin rash. Skin and
clothing that come in contact
with lubricating oil should be
thoroughly washed immediately.
Saturated clothing should be
removed immediately. Areas in
which lubricating oil is used
should be well-ventilated to keep
fumes to a minimum.
(1)
Coat gasket (12) with lubricating oil and
install gasket (12) on filter base. (5).
(2)
Install two relief valves (10) in relief valve
assembly (10).
(3)
Install relief valve assembly (10) and
spring (8) on hydraulic filter (7).
(4)
Coat preformed packings (9) with
lubricating oil and install on hydraulic
filter (7).
(5)
Install filter (7) on filter base (5).
Ensure gasket and filter cover are intact before installation. Failure to comply could result in
damage to equipment.
NOTE
Filter cover is installed on filter base by allowing screw heads to pass through large holes in
filter cover and turning filter cover until screw heads are positioned in small holes in filter
cover.
(6)
Coat gasket (6) with lubricating oil and install gasket (6) on filter cover (4).
(7)
Install filter cover (4) on filter base (5).
(8)
Tighten six screws (3) on filter cover (4) to 18 lb-ft (24 N.m).
(9)
Tighten filler cap (1) on hydraulic reservoir (2).
d.
Follow-On Maintenance:
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
