|
| |
TM 9-2320-364-20-5
21-121
NOTE
All seven red marker lights
are installed the same way.
Perform Steps (5) through (8)
for rear marker light with
lamp.
Perform Steps (10) through
(14) for rear marker light
with LED.
(5)
Install gasket (14), marker light assembly
(8), two screws (13), wire 1435 (12) and two
locknuts (11) on marker light bracket (15).
Corrosion inhibitor contains
alkali. Do not get in eyes; wear
goggles/safety glasses when
using. Avoid contact with skin.
In case of contact, immediately
wash area with soap and water. If
eyes are contacted, flush eyes
with large amounts of water for at
least 15 minutes and get
immediate medical attention.
(6)
Apply anti-corrosion silicone compound to
inside of rear lamp socket (10).
(7)
Install lamp (9) in lamp socket (10).
(8)
Install lens cover (7) with two screws (6) in
light assembly (8).
(9)
Apply corrosive preventive compound to
wire 1435 (12).
7
6
8
9
10
11
13
14
15
12
|
