|
| |
TM 9-2320-364-20-5
21-135
NOTE
Ensure retaining ring is fully
seated in Step (3).
(3)
With the aid of an assistant, position slider
pivot pin (4) in arm assembly (5) and install
washer (3) and retaining ring (2).
(4)
Remove lifting device from slider assembly
(1).
(5)
Check that pivot lock pin (6) properly locks
into handle (7).
NOTE
If pivot lock pin does not
properly lock into handle perform
Steps (6) through (10).
(6)
Remove four screws (8), shim(s) (9) (if
present) and handle (7) from arm assembly
(5).
(7)
Remove or add shim(s) (9) to arm assembly
(5) as required.
Adhesives, solvents, and sealing
compounds can burn easily, can give
off harmful vapors, and are harmful
to skin and clothing. To avoid injury
or death, keep away from open fire
and use in well-ventilated area. If
adhesive, solvent, or sealing
compound gets on skin or clothing,
wash immediately with soap and
water.
(8)
Apply sealing compound (loctite 242) to
threads of four screws (8).
1
2
3
4
5
6
7
5
8
7
9
|
