|
| |
TM 9-2320-364-20-5
21-155
b.
Installation.
NOTE
Right rear roller bracket and
left rear roller bracket are
identical unless noted.
Right rear roller bracket is
shown.
(1)
Position stow plate (26), two screws (24) and
locknuts (25) to rear roller bracket (1). Do
not tighten screws.
NOTE
Perform Step (2) if wire rope was
removed.
(2)
Install swaging sleeve (23) to wire rope (20).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in
well-ventilated area. If adhesive,
solvent, or sealing compound gets
on skin or clothing, wash
immediately with soap and water.
(3)
Apply sealing compound to threads of screw
(18) and screw (21).
(4)
Install screw (21), washer (22) and loop end
of wire rope (20) on rear roller bracket (1).
Do not tighten screw.
(5)
Position screw (18), washer (19) and end of
wire rope (20) on rear roller bracket (1).
NOTE
Wire must be pulled tight against
roller bracket when installed.
(6)
Wrap wire (20) around screw (18) and under
washer (19) and tighten screws (18) and
(21).
(7)
Install light mounting plate (17), two screws
(15) and locknuts (16) to rear roller bracket
(1).
20
18
19
15
16
17
18
19
20
23
24
25
26
1
22
21
|
