|
| |
TM 9-2320-364-20-5
21-199
d.
Adjustment.
(1)
Remove screw (1) and washer (2) in boss (3)
of flipper bracket (4).
(2)
Remove screw (5) and washer (6) in boss (7)
of flipper bracket (4).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in
well-ventilated area. If adhesive,
solvent, or sealing compound gets
on skin or clothing, wash
immediately with soap and water.
(3)
Apply sealing compound to threads of screw
(5).
(4)
Position washer (6) and screw (5) on pin (8)
and boss (7) of flipper bracket (4).
(5)
Tighten screw (5) until washer (6) is tight
against boss (7) of flipper bracket (4).
(6)
Loosen screw (5) approximately 1/4 turn
until washer (6) moves freely.
(7)
Apply sealing compound to threads of screw
(1).
(8)
Position washer (2) and screw (1) on pin (9)
and boss (3) of flipper bracket (4).
(9)
Tighten screw (1) until washer (2) is tight against boss (3) of flipper bracket (4).
(10)
Loosen screw (1) approximately 1/4 turn until washer (2) moves freely.
(11)
Ensure washer (6) on boss (7) moves freely.
NOTE
Let sealing compound cure, approximately 15 minutes before operating flipper bracket.
(12)
Rotate flipper bracket (4) and ensure screws (1) and (5) rotate flipper bracket, and washers (2) and (6)
move freely.
2
1
3
4
5
6
7
8
9
|
