|
| |
TM 9-2320-364-20-5
B-1
APPENDIX B
MAINTENANCE ALLOCATION CHART (MAC)
Section I. INTRODUCTION
B-1. GENERAL.
a.
This section provides a general explanation of all maintenance and repair functions authorized at various
maintenance levels.
b.
The Maintenance Allocation Chart (MAC) in Section II designates overall authority and responsibility for
the performance of maintenance functions on the identified end item or component. The application of the
maintenance functions to the end item or component will be consistent with the capacities and capabilities of the
designated maintenance levels.
c.
Section III lists the tools and test equipment required for each maintenance function as referenced from
Section II.
d.
Section IV lists remarks (identified by an alphabetic code in Column 6 of the MAC) to provide a ready
reference to the definition of the remark.
B-2. MAINTENANCE FUNCTIONS.
Maintenance functions will be limited to and defined as follows:
a.
Inspect. To determine the serviceability of an item by comparing its physical, mechanical, and/or
electrical characteristics with established standards through examination (e.g., by sight, sound, or feel).
b.
Test. To verify serviceability by measuring the mechanical, pneumatic, hydraulic, or electrical
characteristics of an item and comparing those characteristics with prescribed standards.
c.
Service. Operations required periodically to keep an item in proper operating condition, i.e., to clean
(includes decontaminate, when required), to preserve, to drain, to paint, or to replenish fuel, lubricants, chemical
fluids, or gases.
d.
Adjust. To maintain or regulate, within prescribed limits, by bringing into proper or exact position, or by
setting the operating characteristics to specified parameters.
e.
Align. To adjust specified variable elements of an item to bring about optimum or desired performance.
f.
Calibrate. To determine and cause corrections to be made or to be adjusted on instruments or test,
measuring, and diagnostic equipments used in precision measurement. Consists of comparisons of two
instruments, one of which is a certified standard of known accuracy, to detect and adjust any discrepancy in the
accuracy of the instrument being compared.
g.
Remove/Install. To remove and install the same item when required to perform service or other
maintenance functions. Install may be the act of emplacing, seating, or fixing into position a spare, repair part, or
module (component or assembly) in a manner to allow the proper functioning of an equipment or system.
|
