|
| |
TM 9-2320-364-20-5
D-16
D-14. JUMPER HARNESS (DDEC III).
(1)
Fabricate from 16-gage wire.
(2)
Using wire cutters, cut five pieces of 16-gage wire to 180 in. (457 cm).
(3)
Strip both ends of each wire .25 inch (6.4 mm).
(4)
Crimp five terminals (PN 12077413) and five cable seals (PN 12015193) on wires.
(5)
Insert terminals and cable seals into connector body (PN 12124634) as illustrated.
(6)
Secure terminals and cable seals in connector body with secondary lock (PN 12052816).
(7)
Attach terminals (PN D-351-38) to other end of wires 150, 150 & 151, and 240 & 241, as illustrated.
|
