|
| |
TM 9-2320-364-20-5
14-8
14-3. STEERING TOE-IN ADJUSTMENT (CONT).
NOTE
For Axle No. 1 and 5 perform
Step (17).
For Axle No. 2 perform Step
(18).
(17)
Install locknut (8) on clamp (9) and tie-rod
end (6). Tighten locknut (8) on clamp (9) to
80 to 90 lb-ft (108 to 122 N.m).
(18)
Install locknut (8) and clamp (9) on tie-rod
end (6). Tighten locknut (8) on clamp (9) to
50 to 60 lb-ft (68 to 81 N.m).
(19)
Install castle nut (5) on tie-rod end (6).
Tighten castle nut (5) to 150 to 200 lb-ft
(203 to 207 N.m).
NOTE
It may be necessary to further
tighten nut to line up slots for
cotter pin installation.
(20)
Install cotter pin (4) in castle nut (5) and
tie-rod end (6).
(21)
Using hydraulic jack, raise Axle No. 5 (1),
remove jackstands and lower axle.
b.
Follow-On Maintenance:
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
