|
| |
TM 9-2320-364-34-2
12-3
a.
Steering Pump Hydraulic Pump Control Adjustment.
The steering hydraulic system
operates at oil pressures up to
3,000 psi (20,685 kPa). Never
disconnect any hydraulic line or
fitting without first dropping
pressure to zero. Failure to
comply may result in serious
injury or death to personnel.
If steering system hydraulic
adjustments are not performed
in the correct sequence, serious
damage to equipment will occur.
Perform steering system
hydraulic adjustment in the
following sequence.
NOTE
Position drain pan under hoses.
(1)
Open front access cover (1).
(2)
Disconnect hose 2393 (2) and preformed
packing (3) from elbow (4) on steering
manifold (5). Discard preformed packing
(3)
Apply hydraulic oil to preformed
packing (3).
(4)
Position preformed packing (3) on
elbow (4).
(5)
Install flow meter in line between
hose 2393 (2) and elbow (4) on steering
manifold (5).
(6)
Fully open load valve on flow meter.
(7)
Start engine.
|
