|
| |
TM 9-2320-364-34-2
12-8
12-2. STEERING SYSTEM HYDRAULIC ADJUSTMENT (CONT).
(20)
Remove 22 screws (8), lockwashers (9),
washers (10) and cab engine access
panel (11). Discard lockwashers.
(21)
Remove sequence valve cover (12) from
set screw (13).
NOTE
Turning sequence valve set screw
to the right will increase pump
output pressure and turning to
the left will decrease pump
output pressure. Each full turn
will change the output pressure
about 150 psi (1,034 kPa).
(22)
Turn set screw (13) and adjust sequence
valve (14) relief pressure.
(23)
Repeat Steps (16) through (22) until 1,800 to
1,825 psi (12,411 to 12,583 kPa) are present.
(24)
Shut OFF engine.
(25)
Install sequence valve cover (12).
(26)
Install cab engine access panel (11) with 22
washers (10), lockwashers (9) and screws (8)
|
