|
| |
TM 9-2320-364-34-2
12-28
12-5. 90 DEGREE GEARBOX REPAIR (CONT).
NOTE
Tag and mark pinion shaft and
output shaft components during
removal.
(11)
Remove locknut (15), bevel gear (16) and
key (17) from pinion shaft (14). Discard
locknut and key.
Use care when removing
retaining rings. Retaining rings
are under tension and can act as
projectiles when released
causing injury to personnel.
(12)
Remove oil seal (18), retaining ring (19),
cone bearing (20) and pinion housing (10)
from pinion shaft (14). Discard oil seal and
retaining ring.
(13)
Remove cone bearing (20) and bearing
cups (21) from pinion housing (10).
(14)
Matchmark housing (1) and open end
cap (23).
NOTE
Note the number of gaskets
removed during disassembly.
(15)
Remove four screws (22), open end cap (23),
gasket (24), preformed packing (25) and
output shaft (26) from housing (1). Discard
gasket and preformed packing.
(16)
Remove oil seal (27), bearing cup (28) and
open end cap (23) from output shaft (26).
Discard oil seal.
|
