| |
TM 9-2320-364-34-2
12-64
12-9. FRONT STEERING GEAR AND PITMAN ARM REPLACEMENT (CONT).
Front steering gear needs to be supported on transmission jack with two wooden blocks
located in front of front steering gear. Wooden blocks should be 4 by 6 by 11 in. and
2 by 4 by 11 in. and should be positioned as shown.
(21)
Position mounting bracket (23) on two
wooden blocks and transmission jack.
(22)
Secure front steering gear (7) to
transmission jack with chains.
(23)
Remove lifting device from mounting
bracket (23).
(24)
With the aid of an assistant, raise
transmission jack and position front steering
gear (7) until screw holes are aligned in
bracket (23).
(25)
With the aid of an assistant, position front
drag link end (11) and intergear link
end (13) in pitman arm (12).
(26)
With the aid of an assistant, install
screws (18) and locknuts (17) in
bracket (23).
(27)
With the aid of an assistant, install
screw (21), washer (22), screw (20)
and nuts (19) in bracket (23).
(28)
Remove chains and two wooden blocks from
forward steering gear (7) and transmission
jack.
(29)
Install end yoke (16) on front steering
gear (7) with screw (15) and locknut (14).
(30)
Install screw (9), lockwasher (10) and nut (8)
in pitman arm (12) in intergear link end (13).
(31)
Install screw (9), lockwasher (10) and nut (8)
in pitman arm (12) in drag link end (11).
|