|
| |
TM 9-2320-364-34-2
3-87
(4)
Remove screw (12), lockwasher (13) and
washer (14) from pulley drive shaft (15).
Discard lockwasher.
(5)
Install puller with puller screws in vibration
damper (16).
(6)
Using puller, remove vibration damper (16)
from pulley drive shaft (15).
NOTE
If key is loose, perform Step (7).
(7)
Remove and discard key (17) from pulley
drive shaft (15).
(8)
Remove puller screws and puller from
vibration damper (16).
(9)
Remove screw (18), lockwasher (19) and
washer (20) from front balance cover (6).
Discard lockwasher.
(10)
Remove screw (21) and washer (22) from
front balance cover (6).
(11)
Remove two screws (23), lockwashers (24),
cushion clip (25) and two washers (26) from
front balance cover (6). Discard
lockwashers.
(12)
Remove screw (27), lockwasher (28) and
washer (29) from front balance cover (6).
Discard lockwasher.
(13)
Remove locknut (30), screw (31),
lockwasher (32) and washer (33) from front
balance cover (6). Discard lockwasher and
locknut.
(14)
Remove locknut (34), screw (35),
lockwasher (36) and washer (37) from front
balance cover (6). Discard lockwasher and
locknut.
(15)
Remove three nuts (38), screws (39),
washers (40) and lockwashers (41) from
front balance cover (6). Discard
lockwashers.
(16)
Remove front balance cover (6) and
gasket (42) from end plate (43). Discard
gasket.
|
