|
| |
TM 9-2320-364-34-2
3-90
3-10. VIBRATION DAMPER/FRONT BALANCE COVER REPLACEMENT (CONT).
(8)
Install washer (29), lockwasher (28) and
screw (27) in front balance cover (6).
Tighten screw to 35 to 39 lb-ft (47 to 53
N.m).
(9)
Install cushion clip (25), two washers (26),
lockwashers (24) and screws (23) in front
balance cover (6). Tighten screws to 30 to 35
lb-ft (41 to 47 N.m).
(10)
Install washer (22) and screw (21) in front
balance cover (6). Tighten screw to 137 to
147 lb-ft (186 to 199 N.m).
(11)
Install washer (20), lockwasher (19) and
screw (18) in front balance cover (6).
Tighten screw to 71 to 75 lb-ft (96 to 102
N.m).
NOTE
If key was removed, perform
Step (12).
(12)
Install key (17) in pulley drive shaft (15).
(13)
Install vibration damper (16) on pulley drive
shaft (15).
(14)
Install washer (14), lockwasher (13) and
screw (12) in pulley drive shaft (15).
Tighten screw to 25 lb-ft (34 N.m).
(15)
Position washer (10) and alternator support
arm (11) on front balance cover (6).
(16)
Install washer (9), lockwasher (8) and
screw (7). Tighten screw to 180 lb-ft
(244 N.m).
(17)
Position engine lift bracket (5) on front
balance cover (6) with two lockwashers (3)
and (4) and screws (2) and (1).
(18)
Tighten screw (2) on engine lift bracket (5)
to 71 to 75 lb-ft (96 to 102 Nm).
(19)
Tighten screw (1) on engine lift bracket (5)
to 137 to 147 lb-ft (186 to 199 N.m).
|
