|
| |
TM 9-2320-364-34-2
3-94
3-11. VIBRATION DAMPER REPLACEMENT (CONT).
(4)
Turn cone (4) clockwise and remove from
crankshaft (3) inside trunnion support (5).
(5)
Remove and discard preformed packing (6)
from cone (4).
NOTE
Note location of screws prior to
removal.
(6)
Remove eight lockscrews (7), mounting
plate (8) and hub assembly (9) from
vibration damper (1). Discard lockscrews.
NOTE
Perform Step (7) only if pins are
damaged.
(7)
Remove and discard two pins (10) from hub
assembly (9).
b.
Installation.
NOTE
Perform Steps (1) and (2) only if
pins were removed during
removal.
(1)
Install two pins (10) in hub assembly (9).
(2)
Position two pins (10) through hub
assembly (9) until pins stick out of hub
assembly 3/8 in. (9.5 mm).
NOTE
Install screws as noted prior to
removal.
(3)
Install mounting plate (8) and hub
assembly (9) on vibration damper (1) with
eight lockscrews (7). Tighten lockscrews to
75 to 85 lb-ft (102 to 115 N.m).
|
