|
| |
TM 9-2320-364-34-2
3-98
3-12. CRANKCASE FRONT COVER AND OIL SEAL REPLACEMENT (CONT).
(3)
Remove two screws (9), lockwashers (10)
and upper trunnion support assembly (11)
from lower trunnion support assembly (8).
Discard lockwashers.
(4)
Raise lifting device until engine (2) raises
only high enough so lower trunnion
assembly (8) can be removed.
(5)
Remove lower trunnion assembly (8) from
engine support (12).
NOTE
Note position of ring prior to
removal.
(6)
Remove ring (13) from trunnion plate (14).
(7)
Remove two washers (15) from mounts (16).
Ensure trunnion plate is fully
supported upon removal of eight
screws. Trunnion plate may fall
and cause damage to equipment.
(8)
Remove four screws (17) and
lockwashers (18) from trunnion plate (14).
Discard lockwashers.
(9)
Remove two screws (19) and
lockwashers (20) from trunnion plate (14).
Discard lockwashers.
(10)
Remove two screws (21) and
lockwashers (22) from trunnion plate (14).
Discard lockwashers.
(11)
Remove trunnion plate (14) from crankcase
front cover (23).
|
