|
| |
TM 9-2320-364-34-2
3-124
3-19. PUSH ROD AND CAM FOLLOWER REPLACEMENT (CONT).
NOTE
There must be 0.005 in. (0.127
mm), but not more than 0.010 in.
(0.254 mm), clearance between
cam follower guide and cam
follower.
(6)
Insert 0.005 in. (0.13 mm) feeler gage
between cam follower guide (4) and legs of
cam followers (5).
(7)
Tap cam follower guide (4) lightly with soft
faced hammer until feeler gage is snug.
(8)
Tighten screws (2) to 180 lb-in (20 N.m).
(9)
Remove feeler gage from cam follower
guide (4) and legs of cam followers (5).
(10)
Check clearance again as in Step (7).
(11)
If there is not enough clearance, loosen
screws (2), move guide (4) and repeat
Steps (7) through (10) until proper
clearance is obtained.
(12)
If proper clearance cannot be obtained,
replace cam follower guide (4).
c.
Follow-On Maintenance:
Install cylinder head, (Para 3-7).
Install rocker arms, (Para 3-20).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
