|
| |
TM 9-2320-364-34-2
3-133
NOTE
It is not necessary to remove
screws from torque rod.
(3)
Remove two locknuts (5), washers (6) and
spacer plate (7) from torque rod screws (8).
Discard locknuts.
NOTE
Torque rod screws are pulled out
only far enough to access two
spacers.
(4)
Pull torque rod screws (8) out and remove
two spacers (9).
(5)
Remove two locknuts (10) and screws (11)
from bottom gusset (12) and
crossmember (13). Discard locknuts.
(6)
Remove four locknuts (14) and screws (15)
from bottom gusset (12) and
crossmember (13). Discard locknuts.
NOTE
To remove locknuts from top
gussets, insert extension rod
through holes in bottom gussets.
(7)
With the aid of an assistant, remove two
locknuts (16) and screws (17) from top
gusset (18) and crossmember (13). Discard
locknuts.
(8)
With the aid of an assistant, remove four
locknuts (14) and screws (15) from top
gusset (18) and crossmember (13). Discard
locknuts.
(9)
Remove locknut (19) and screw (20) from
spring hanger bracket (21). Discard locknut.
(10)
Remove crossmember (13) from gussets
(18) and (12).
|
