|
| |
TM 9-2320-364-34-2
4-15
a.
Removal.
Ensure all debris is kept clear of blower during removal. Failure to comply may result in
damage to equipment.
NOTE
Remove cable ties as required.
(1)
Remove adapter (1) from nut (2).
(2)
Loosen adapter (3) and remove from blower drive support (4). Slide adapter fitting (3) towards
blower (5).
(3)
Loosen clamp (6) on blower drive support (4).
(4)
Disconnect tachometer drive connector (7).
(5)
Remove two screws (8), lockwashers (9), washers (10) and cushion clips (11) from rear of engine (12) and
wiring harness (13). Discard lockwashers.
|
