|
| |
TM 9-2320-364-34-2
5-32
5-9. FAN DRIVE MOTOR REPLACEMENT (CONT).
NOTE
Perform Step (9) if fan
support assembly was
removed during removal. If
fan support assembly was
not removed, go on
Step (10).
In Step (9), two locknuts on
left hand side of truck do
not get tightened. Only
locknuts located on right
hand side of frame are
tightened.
(9)
Install two fan support assemblies (5) and
three air hose brackets (8) on frame (9) with
four screws (7) and locknuts (6).
NOTE
Ensure fan drive motor is
installed as noted during
removal.
Fan drive motor screws will
be tightened in radiator
installation during fan
adjustment.
(10)
Position fan drive motor (4) on fan support
assembly (5) with four screws (2) and
locknuts (1) in fan motor plate (3).
c.
Follow-On Maintenance:
Install suction fan, (Para 5-8).
END OF TASK
|
