|
| |
TM 9-2320-364-34-2
6-81
(11)
Tap end of camshaft pulley (20) with
soft-faced hammer to take up end play.
(12)
Insert alignment tool in TRS hole (21) of
bracket (10).
NOTE
There is a notch on the edge of
the pulse wheel next to the
correct TRS timing pin.
(13)
Move bracket (10) until notch in tool
engages with TRS timing pin (22) on pulse
wheel (23).
(14)
Tighten two sockethead screws (11) and
remove alignment tool.
(15)
Tap end of camshaft pulley (20) again to
take up end play.
(16)
Install SRS/TRS (7) in bracket (10) with
retaining clip (9) and screw (8). Do not
tighten.
NOTE
When properly adjusted, there
should be .018 - .022 in. (.46 -
.56 mm) between pulse wheel
teeth and the end of the sensor.
(17)
Position a .020 in. (.50 mm) feeler gage
between TRS (7) and the TRS pin on the
pulse wheel (23).
(18)
Slide the SRS/TRS (7) against feeler gage
and tighten screw (8).
(19)
Connect two connectors (6) to SRS/TRS (7).
6
7
8
9
10
12
21
12
22
11
10
23
20
ALIGNMENT
TOOL
|
