|
| |
TM 9-2320-364-34-2
6-106
Materials/Parts
Cable Ties (Item 9, Appendix B)
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Condition
Engine OFF, (TM 9-2320-364-10)
Wheels chocked, (TM 9-2320-364-10)
Batteries disconnected, (TM 9-2320-364-20)
Left side noise panel removed,
(TM 9-2320-364-20)
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 240, Appendix F)
Connector Remover (Item 42, Appendix F)
6-14. DDEC ENGINE POWER WIRE HARNESS REPLACEMENT.
a.
Removal.
Allow engine to cool before performing this procedure or injury to personnel may occur.
NOTE
Remove cable ties as required.
(1)
Open engine cover (1).
(2)
Remove two screws (2) and cover plate (3).
Use harness connector remover. Do not use a screwdriver to pry up the lock arm. Damage to
connector could result.
(3)
Using connector remover, disconnect MC17 connector (4) from electronic control module (5).
|
