|
| |
TM 9-2320-364-34-2
6-109
Materials/Parts
Cable Ties (Item 9, Appendix B)
Tags, Identification (Item 72, Appendix B)
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Condition
Engine OFF, (TM 9-2320-364-10)
Wheels chocked, (TM 9-2320-364-10)
Batteries disconnected, (TM 9-2320-364-20)
DDEC II ECM removed,
(TM 9-2320-364-20)
Inner fender removed, (right side only),
(TM 9-2320-364-20)
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 240, Appendix F)
Connector Remover (Item 42, Appendix F)
6-15. DDEC II WIRE HARNESS REPLACEMENT.
a.
Removal.
Engine must be cool before performing maintenance. Failure to comply may result in
injury to personnel.
NOTE
Tag and mark all wires before removal.
(1)
Open clip (1) and remove DDEC II wire harness (2) from clip.
|
