|
| |
TM 9-2320-364-34-2
6-129
(12)
Install two cushion clips (21) on DDEC
battery power wire harness (18).
(13)
Install two cushion clips (21) on fender (22)
with two screws (20) and locknuts (19).
(14)
Install cushion clip (16) on DDEC battery
power wire harness (18).
(15)
Install cushion clip (16) on bracket (17) with
screw (15) and locknut (14).
NOTE
MC14 connector in Step (16) is
on DDEC III trucks only.
(16)
Push two wires 240 (3) and (5) and two wires
241 (8) and (10) and MC14 connector (11)
through grommet (12) on electrical control
box (13).
NOTE
Perform Step (17) for DDEC III
trucks only.
(17)
Connect MC14 connector (11).
(18)
Connect wire 241 (10) on circuit breaker
CB22 (9).
(19)
Install wire 241 (8) on circuit breaker
CB22 (9) with lockwasher (7) and screw (6).
(20)
Connect wire 240 (5) on circuit breaker
CB23 (4).
(21)
Install wire 240 (3) on circuit breaker
CB23 (4) with lockwasher (2) and screw (1).
c.
Follow-On Maintenance:
Install Electronic Control Box (ECB) covers, (TM 9-2320-364-20).
Install cab engine access panel, (TM 9-2320-364-20).
Install left fender front skirt, (TM 9-2320-364-20).
Install left side noise panel, (TM 9-2320-364-20).
Connect batteries, (TM 9-2320-364-20).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
