|
| |
TM 9-2320-364-34-2
6-172
6-19. CAB WIRE HARNESS REPLACEMENT (CONT).
NOTE
Installation of bracket in Step
(90) is for DDEC III engines
only.
(90)
Install bracket (25), MC13 diagnostic
connector (24), two screws (23) and locknuts
(22) on left side of dash panel (26).
(91)
Connect I.D. and clearance light 1012
connector (21).
(92)
Remove locknut (12) and screw (13) in
cab (4). Discard locknut.
(93)
Install shield wire (20), shield wire (19),
shield wire (18), wire 1435 (17), shield
wire (16), wire 1435 (15) and
wire 1435 (14), on bracket (8) with
screw (13) and locknut (12).
|
