|
| |
TM 9-2320-364-34-2
6-216
6-25. ELECTRONIC CONTROL BOX WIRE HARNESS REPLACEMENT (CONT).
(29)
Remove wire 1082/1340/1487/1534 (88)
from circuit breaker CB15 (89).
(30)
Remove wires 1093/1888 (90) from circuit
breaker CB16 (91).
(31)
Remove wire 1880 (92) from circuit
breaker CB17 (93).
(32)
Remove screw (65), lockwasher (66), wire
1431 (94), 1676/1665C/1026 (95) and wire
1431 (96) from circuit breaker CB20 (97).
Discard lockwasher.
NOTE
Perform Step (33) for DDEC III
trucks only.
(33)
Disconnect MC14 connector (98).
(34)
Remove ECB wire harness (99) from
ECB (3).
b.
Installation.
NOTE
Install cable ties as required.
Refer to Table 6-4 for circuit
breaker wiring and
mounting positions.
(1)
Position ECB wire harness (99) in ECB (3).
NOTE
Perform Step (2) for DDEC III
trucks only.
(2)
Connect MC14 connector (98).
(3)
Install wire 1676/1665C/1026 (95) and wire
1431 (96) on circuit breaker CB20 (97).
(4)
Install wire 1431 (94) on circuit breaker
CB20 (97) with lockwasher (72) and
screw (71).
(5)
Install wire 1880 (92) on circuit breaker
CB17 (93).
(6)
Install wire 1093/1888 (90) on circuit
breaker CB16 (91).
(7)
Install wire 1082/1340/1487/1534 (88) on
circuit breaker CB15 (89).
|
