|
| |
TM 9-2320-364-34-2
6-252
6-29. CHASSIS WIRE HARNESS REPLACEMENT (CONT).
NOTE
There are two wires secured by
screw and nut. Remove only wire
1435 of chassis wire harness and
secure remaining wire with screw
and nut.
(17)
Remove nut (46), wire 1435 (47), and wire
1435 (48) of chassis wire harness (15) and
screw (49).
(18)
Position wire 1435 (47) screw (49) and nut
(46).
NOTE
There are two wires located on
24 volt load terminal of polarity
protection control. Remove only
wire 1431 and position remaining
wire back on terminal.
(19)
Remove nut (50), lockwasher (51) and wire
1431 (52) from 24 volt load terminal (53)
of polarity protection control (54). Discard
lockwasher.
(20)
Position nut (50) on 24 volt load terminal
(53).
49
15
46
52
50
51
47
48
53
54
|
