|
| |
TM 9-2320-364-34-2
6-269
(4)
Guide wires (206) on MC16 connector (204) through slot (207) on bracket (203) on rear of truck (205).
(5)
Install two screws (202), locknuts (201) and MC16 connector (204) on bracket (203).
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
NOTE
Perform Steps (6) and (7) for Model A connector.
(6)
Push boot (200) back on chassis wire harness (15). Apply a thin strip of sealing compound around rear of
MC16 connector (204) and slide boot (200) on MC16 connector (204).
(7)
Install cable tie (199) over boot (200) on MC16 connector (204). Apply a thin strip of sealing compound
to rear of boot (200) where wires (15) enter boot (200).
SERVICE
203
204
199
206
202
205
207
201
200
15
SEALING COMPOUND
SEALING COMPOUND
|
