|
| |
TM 9-2320-364-34-2
6-279
(52)
Guide wires (104) of harness (15) from MC27 connector (108) through slot (110) on bracket (107).
(53)
Install two screws (106), locknuts (105) and MC27 connector (108) on bracket (107).
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
NOTE
Perform Steps (54) and (55) for Model A connector.
(54)
Push boot (103) back on chassis wire harness (104). Apply a thin strip of sealing compound around rear
of MC27 connector (108) and slide boot (103) on MC27 connector (108).
(55)
Install cable tie (102) over boot (103) on MC27 connector (108). Apply a thin strip of sealing compound
to rear of boot (103) where wires (15) enter boot (103).
|
