|
| |
TM 9-2320-364-34-2
7-11
Materials/Parts
Oil, Hydraulic (Item 34, Appendix B)
Tags, Identification (Item 72, Appendix B)
Packing, Preformed (Item 400, Appendix E)
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Condition
Transmission solenoid wiring harness removed,
(Para 7-2)
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 240, Appendix F)
Bit Set, Screwdriver (Item 17, Appendix F)
Wrench Set, Socket 3/8 in. Drive
(Item 273, Appendix F)
Wrench, Torque (0-60 N.m)
(Item 276, Appendix F)
7-8. TRANSMISSION SOLENOID PRESSURE SWITCH REPLACEMENT.
a.
Removal.
NOTE
Both pressure switches are removed and installed the same way.
Tag, mark and note position of each pressure switch prior to removal.
(1)
Disconnect connector (1) from solenoid wire
harness assembly (2).
(2)
Remove two screws (3), pressure switch (4)
and preformed packing (5) from solenoid
plate (6). Discard preformed packing.
b.
Installation.
(1)
Apply hydraulic oil to preformed
packing (5).
(2)
Install preformed packing (5), pressure
switch (4) and two screws (3) on solenoid
plate (6). Tighten screws to 60 to 84 lb-in
(7 to 9 N.m).
(3)
Connect connector (1) on solenoid wire
harness assembly (2).
c.
Follow-On Maintenance:
Install transmission solenoid wiring harness,
(Para 7-2).
END OF TASK
|
