|
| |
TM 9-2320-364-34-2
7-13
(3)
Support driveshaft (1) and remove four
screws (5), two bearing straps (6) and
driveshaft from lower transfer case yoke (7)
Lower driveshaft to ground.
(4)
Support driveshaft (8) and remove four screws (9), two bearing straps (10) and driveshaft from
transmission yoke (11). Position driveshaft on crossmember (12).
(5)
Position drain pan under transmission
yoke (11).
(6)
Using flange holder to hold transmission
yoke (11), remove locknut (13) and
transmission yoke from output shaft (14).
Discard locknut.
(7)
Remove dust shield (15) and oil seal (17)
from rear cover (16). Discard dust shield
and oil seal.
|
