|
| |
TM 9-2320-364-34-2
7-15
(8)
Remove driveshaft (8) from crossmember (12) and position driveshaft on transmission yoke (11).
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
(9)
Apply sealing compound to threads of four
screws (9).
(10)
Install two bearing straps (10), four
screws (9) and driveshaft (8) on transmission
yoke (11). Tighten screws to 130 lb-ft
(176 N.m).
Driveshaft weighs 90 lbs (41 kg).
The aid of an assistant is
required to prevent possible
injury to personnel.
NOTE
Driveshaft should be installed
with arrow mark on shaft
pointing toward front of truck.
(11)
With the aid of an assistant, position
driveshaft (1) in lower transfer case yoke (7)
and Axle No. 2 yoke (4).
(12)
Apply sealing compound to the threads of
four screws (5).
(13)
Install four screws (5), two bearing straps (6)
and driveshaft (1) on transfer case yoke (7).
Tighten to 130 lb-ft (176 N.m).
|
