|
| |
TM 9-2320-364-34-2
7-26
7-10. FLYWHEEL AND TORQUE CONVERTER TURBINE REPAIR (CONT).
(3)
Pack turbine shaft seal ring groove (17) with
grease and install seal ring (16) in groove.
(4)
Coat torque converter gasket (15) with
hydraulic oil and install on converter
pump (7).
(5)
Install two guide pins into flywheel (1) mounting holes.
Flywheel weighs 175 lbs (79 kg). Attach suitable lifting device prior to installation to prevent
possible injury to personnel.
(6)
With the aid of an assistant, lift and align flywheel (1) on converter pump (7).
(7)
Position washer (9) and screw (8) through access hole in converter housing (10).
(8)
Remove lifting device from lifting bracket.
(9)
Remove guide pins from flywheel (1).
(10)
Using lifting bracket as an aid to turn flywheel (1), position 29 washers (9) and screws (8) through access
hole in converter housing (6).
(11)
Tighten 30 screws (8) to 41 to 49 lb-ft (56 to 66 N.m).
|
