|
| |
TM 9-2320-364-34-2
8-20
8-3. TRANSFER CASE ASSEMBLY SUPPORT REPLACEMENT (CONT).
(2)
Installation.
NOTE
If frame bracket was removed, perform Step (a).
(a)
With the aid of an assistant, install two screws (27), four screws (26) and right frame bracket (24) on
frame (17) with six locknuts (25).
(b)
Position two upper mounts (23) on
right frame bracket (24).
Failure to clear neutral
start switch during
installation could damage
neutral start switch.
(c)
Feed neutral start connector wires (20)
through hole in support bracket (6) and
position support bracket (6) over
neutral start switch (22) and on upper
mounts (23) and transfer case (8).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in a well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(d)
Apply sealing compound on threads of
six screws (21).
(e)
Position three washers (19) and
screws (21) in support bracket (6) and
rear of transfer case (8).
|
