|
| |
TM 9-2320-364-34-2
9-47
(10)
Using a mechanical puller remove seal (13)
and bearing (14) from pivot and spindle
assembly (5). Discard seal and bearing.
(11)
Remove steering stop bolt (15) and nut (16)
from pivot and spindle assembly (5).
(12)
Remove spindle ring (17) from spindle
assembly (5).
(13)
Remove seal race (18) from pivot and
spindle assembly (5).
b.
Installation.
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound gets
on skin or clothing, wash
immediately with soap and water.
(1)
Apply sealing compound to inside of seal
race (18).
(2)
Install seal race (18) on pivot and spindle
assembly (5).
(3)
Apply sealing compound to outside of
spindle ring (17).
(4)
Install spindle ring (17) on spindle
assembly (5).
(5)
Install steering stop bolt (15) and locking
nut (16) on pivot and spindle assembly (5).
(6)
Lightly coat seal (13) and bearing (14) with
grease.
(7)
Install bearing (14) in pivot and spindle
assembly (5).
(8)
Install seal (13) in pivot and spindle
assembly (5).
|
