|
| |
TM 9-2320-364-34-2
9-53
a.
Removal.
The following Steps (1) and (2) keep clutch gears from disengaging after wheel end
assembly is removed. Failure to perform Steps (1) and (2) makes installation of wheel end
assembly difficult.
Ensure clutch gears are fully engaged prior to Steps (1) and (2) or damage to parts may
occur.
NOTE
Tag and mark all parts prior to removal.
Wheel end assemblies on left side of truck contain the steering arm. Wheel end assemblies
on right side of truck contain the upper cover.
Axle No. 1, 2 and 5 Axle wheel end assemblies are removed the same way. Axle No. 1 is
shown in illustration. Axles No. 2 and 5 are similar.
Steps (1) and (2) are for right side wheel end assembly removal on Axle No. 1 and 5 only.
Steps (1) and (2) are for left side wheel end assembly removal on Axle No. 2 only.
Screw in Step (1) was removed with locking cylinder.
(1)
Position screw (1) in differential housing (2).
(2)
Form a wire hook around fingers of fork (3) and anchor wire with screw (1).
|
