|
| |
TM 9-2320-364-34-2
9-75
NOTE
Equalizer beams and frame must be level to perform axle camber adjustment properly.
Axle camber angle measurements must be taken with relationship to frame. If frame is not
level, the angle the frame is inclined must be added or subtracted from flange assembly
measurement.
Axle flange assembly measurement of 87 degrees 0.5 degrees equals axle camber of three
degrees 0.5 degrees (90 degrees – 87 degrees = 3 degrees).
(26)
Measure the angle (in degrees) that flange
assembly (22) is cambered.
(a)
Position protractor and steel plate
frame at point A. Adjust protractor
zero degrees.
(b)
Position protractor and steel plate
machined surface of the flange
assembly (22) at point B and record
measurement. Measurement shoud
read 87 degrees 0.5 degrees.
(27)
If axle camber is not three degrees 0.5
degrees, add or subtract spacers (64) until
axle camber is correct.
|
