|
| |
TM 9-2320-364-34-2
9-88
9-12. AXLE NO. 4 ASSEMBLY REPLACEMENT (CONT).
(14)
Coat threads on tapered shaft of torque
rod (25) with lubricating oil.
(15)
Install tapered shaft of torque rod (25) in
axle (26).
NOTE
Tighten locknut only until
threads of locknut are fully
engaged with threads of torque
rod. Otherwise, other end of
torque rod will be difficult to
install.
(16)
Position washer (27) and locknut (24) on
torque rod (25).
NOTE
Install same number and size of
spacers as noted during removal.
(17)
With the aid of an assistant, install
spacers (32), bracket (31), truck end of
torque rod (25) and plate (30) on frame
(33) with screws (29) and locknuts (28).
(18)
Tighten locknut (24) on torque rod (25) to
175 to 225 lb-ft (237 to 305 N.m).
(19)
To seat torque rod (25), strike axle torque
rod mount with soft faced hammer, then
retighten locknut (24) on torque rod (25) to
175 to 225 lb-ft (237 to 305 N.m).
(20)
Install air line 2359 (20) to fitting (21).
(21)
Install air line 2422 (18) to fitting (19).
(22)
Connect air line 2893 (22) to axle breather
elbow (23) on left side of axle tube.
|
