|
| |
TM 9-2320-364-34-2
9-120
9-17. AXLE NO. 3 LOCKING CYLINDER REPLACEMENT (CONT).
NOTE
To remove locking cylinder, pull
left and outward.
(4)
Remove locking cylinder (6) from
differential housing (10).
b.
Installation.
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(1)
Coat mating surface of locking cylinder (6)
with adhesive.
(2)
Position locking cylinder (6) on
differential (10).
(3)
Position plastic washer (9), washer (8) and
screw (7) on locking cylinder (6).
NOTE
Install screw so that only three
or four threads of screw are
engaged. Screw is being
installed only to keep screw hole
in locking cylinder aligned with
differential.
(4)
Position washer (4) and screw (3) on locking
cylinder (6).
(5)
Tighten screw (7) on locking cylinder (6) to
22 to 32 lb-ft (30 to 43 N.m).
(6)
Install air line 2421 (1) on fitting (2).
|
