|
| |
TM 9-2320-364-34-2
10-4
10-2. AXLE BRAKE ASSEMBLY REPLACEMENT (CONT).
(2)
Installation.
(a)
Wrap and tape a clean wiping rag around spindle of pivot and spindle assembly (1) to protect
spindle.
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To avoid injury or death, keep away from open fire and
use in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
(b)
Coat end threads of 16 screws (3) with sealing compound.
Brake assembly weighs 80 lbs (36 kg). Attach suitable lifting device prior to installation to
prevent possible injury to personnel.
(c)
Attach lifting device to brake assembly (2).
(d)
Position brake assembly (2) onto pivot and spindle assembly (1).
(e)
Align matchmarks on brake assembly (2) and pivot and spindle assembly (1).
(f)
Install 16 screws (3) on brake assembly (2) and pivot and spindle assembly (1). Tighten screws to
205 lb-ft (278 N.m).
(g)
Remove lifting device from brake assembly (2).
(h)
Remove wiping rag from pivot and spindle assembly (1).
|
