|
| |
TM 9-2320-364-34-2
10-6
10-2. AXLE BRAKE ASSEMBLY REPLACEMENT (CONT).
(2)
Installation.
(a)
Wrap and tape a clean wiping rag around spindle of pivot and spindle assembly (2) to protect
spindle races.
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To avoid injury or death, keep away from open fire
and use in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or
clothing, wash immediately with soap and water.
(b)
Coat end threads of 15 screws (4) with sealing compound.
Brake assembly weighs 80 lbs (36 kg). Attach suitable lifting device prior to installation to
prevent possible injury to personnel.
(c)
Attach lifting device to brake assembly (1).
(d)
Position brake assembly (1) on pivot and spindle assembly (2).
(e)
Align matchmarks on brake assembly (1) and pivot and spindle assembly (2).
(f)
With the aid of an assistant, install 15 screws (4) and locknuts (3) to brake assembly (1) and pivot
and spindle assembly (2). Tighten screws to 205 lb-ft (278 N.m).
(g)
Remove lifting device from brake assembly (1).
(h)
Remove rag from pivot and spindle assembly (2).
|
