|
| |
TM 9-2320-364-34-3
14-6
14-3. FRONT AND REAR SPRING ASSEMBLY REPLACEMENT (CONT).
NOTE
Perform Steps (3) and (4) only when removing rear spring assembly.
(3)
Remove nut (3) and lockwasher (4) from both studs of rod assemblies (5). Discard lockwasher.
(4)
Disconnect rod assemblies (5) from each bracket (6).
NOTE
Bracket and washers apply only when removing rear spring assembly.
(5)
Loosen two nuts (7) and remove bracket (6), two screws (8), nuts (7), lockwashers (9) and washers (10)
from bracket (11). Discard lockwashers.
(6)
Remove two locknuts (12), four
washers (13) and two screws (14) from
spring assemblies (2). Discard locknuts.
Do not stick fingers in pin
holes. Injury to personnel may
result.
NOTE
If pin is hard to remove, use
lifting device to raise or lower
equalizer beam as necessary to
get weight of truck off spring
assembly.
(7)
Remove pins (15) from brackets (16).
(8)
Remove grease fittings (17) from pins (15).
|
