|
| |
TM 9-2320-364-34-3
14-9
(7)
Apply grease to pins (15).
Do not stick fingers in pin holes.
Failure to comply may cause
injury to personnel.
(8)
Using drift punch, align spring
assemblies (2) with brackets (16).
NOTE
Screw slots in pin face down.
Grease fitting hole faces
outside of truck.
(9)
Install pins (15) in brackets (16) and
springs (2).
NOTE
If screw slots do not line up with
screw holes to allow installation
of screws, use turn slot to turn
pin and align screw slots with
screw holes.
(10)
Install two screws (14), four washers (13)
and two locknuts (12) in spring
assemblies (2) and bracket (16). Tighten
locknuts to 45 to 63 lb-ft (61 to 85 N.m).
(11)
Install grease fittings (17) to pins (15).
(12)
Install spacer (20), screw (19) and
locknut (18) to brackets (21). Tighten
locknut to 38 to 45 lb-ft (52 to 61 N.m).
|
