|
| |
TM 9-2320-364-34-3
16-25
(56)
Remove grease fitting (109) from pin (110).
(57)
Remove screw (111), washer (112), pin
support plate (113) and roller (114) from
structural section (91).
(58)
Remove two screws (115) and support plate
(113) from pin (110).
(59)
Remove two nuts (116), lockwashers (117),
screws (118) and (119) and pin
weldment (120) from opposite end of
structural section (91). Discard
lockwashers.
(60)
Remove cable tie from cable (34) and
remove sheave (121) and two thrust
washers (122) from structural section (91).
NOTE
Perform Step (61) if bearing is
damaged.
(61)
Remove bearing (123) from sheave (121).
NOTE
Keep cable straight. Do not
let cable fall to side.
Leave chains connected at
this time.
Pull cable from bottom until
top end falls into structural
section, then stop. Pull both
top and bottom ends of
cable out even.
(62)
Remove cable (34) from structural
section (91).
|
