|
| |
TM 9-2320-364-34-3
16-101
Use care when removing
retaining rings. Retaining rings
are under tension and can act as
projectiles when released causing
injury to personnel.
NOTE
Shaft may be used to remove
bearing.
Note position of bearing
prior to removal.
(14)
Remove preformed packing (29), retaining
ring (30) and bearing (31) from access
cover (17). Discard preformed packing
and retaining ring.
c.
Cleaning/Inspection.
Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles, face
shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and
clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when
using solvent. The flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees
C) and Type III Drycleaning Solvent is 200 degrees F (93 degrees C). Failure to do so may
result in injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts
eyes, immediately flush eyes with water and get immediate medical attention.
(1)
Clean all metal parts in drycleaning solvent.
(2)
Dry parts with cleaning cloth.
(3)
Inspect parts for cracks, breaks, scratches, gouges, pitting and stripped threads.
(4)
Inspect clutch discs for wear. If disc is under 0.064 in. (1.62 mm) thick, replace disc.
(5)
Inspect pressure plates for wear. If pressure plate is under 0.057 in. (1.45 mm) thick, replace pressure
plate.
(6)
Inspect bearing rotation. Bearing should rotate freely.
(7)
Replace damaged parts.
|
