|
| |
TM 9-2320-364-34-3
16-140
16-21. SWING DRIVE BRAKE REPLACEMENT (CONT).
c.
Installation.
(1)
Install disc (7) in swing drive assembly (5).
NOTE
Thick spacer is installed first.
(2)
Install spacer (8), disc (7) and spacer (6) in
swing drive assembly (5).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(3)
Apply adhesive to back of brake cylinder
housing (4).
NOTE
Brake is spring loaded.
(4)
Align and install brake cylinder housing (4)
on swing drive assembly (5).
(5)
Apply sealing compound on threads of four
screws (1).
(6)
Position two stops (3), four washers (2) and
screws (1). Tighten screws to 35 lb-ft
(47 N.m).
d.
Follow-On Maintenance:
Install swing drive motor, (Para 16-20).
Install driveshaft, (TM 9-2320-364-20).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
