|
| |
TM 9-2320-364-34-3
16-240
16-37. SELF-RECOVERY WINCH MANIFOLD REPLACEMENT (CONT).
a.
Removal.
The winch hydraulic system operates at oil pressures up to 3,675 psi (25,339 kPa). Never
disconnect any hydraulic line or fitting without first dropping the pressure to zero. Failure
to comply may result in serious injury or death to personnel.
NOTE
Note position and location of elbows and fittings prior to removal.
Tag and mark connectors, hoses and tubes prior to removal.
Cap and plug hoses, tubes and fittings after removal.
(1)
Loosen screw (1) and disconnect MC121 connector (2) from self recovery winch manifold (3).
(2)
Loosen screw (4) and disconnect MC122 connector (5) from self recovery winch manifold (3).
(3)
Loosen screw (6) and disconnect MC123 connector (7) from self recovery winch manifold (3).
(4)
Remove and discard three gaskets (8) from connectors (2), (5) and (7).
|
